I was adjusting the F.A. control lever following all instructions for making linkage adjustment in page O8B-2(TM10-1563),the clevis pin does not line up with hole in adjustable yoke and hole.I turned the yoke as necessary to line up holes in yoke and control rod lever.It is very important to check this adjustment.[/b]Front Axle Control Lever Adjustment (Banjo)
-
Fernando Mendes
- Lieutenant Colonel
- Posts: 762
- Joined: Tue Jan 02, 2007 3:29 pm
- Location: Santiago-RS-Brasil
Front Axle Control Lever Adjustment (Banjo)
I was adjusting the F.A. control lever following all instructions for making linkage adjustment in page O8B-2(TM10-1563),the clevis pin does not line up with hole in adjustable yoke and hole.I turned the yoke as necessary to line up holes in yoke and control rod lever.It is very important to check this adjustment.[/b]Jeep Willys MB DoD dec,16 1942 s/n:196275
Dodge B3-B 4x2 1952 s/n:90099559
CCKW 353 Banjo 1944 s/n:309623
Dodge B3-B 4x2 1952 s/n:90099559
CCKW 353 Banjo 1944 s/n:309623
-
Fernando Mendes
- Lieutenant Colonel
- Posts: 762
- Joined: Tue Jan 02, 2007 3:29 pm
- Location: Santiago-RS-Brasil
After the adjustment of the FRONT AXLE control lever.
1)Jacking up one of the front wheel.2)put the lever in IN position.3)move the wheel jacked by hand.4)now we can be sure if it is engaging or not after this adjustment. 
Jeep Willys MB DoD dec,16 1942 s/n:196275
Dodge B3-B 4x2 1952 s/n:90099559
CCKW 353 Banjo 1944 s/n:309623
Dodge B3-B 4x2 1952 s/n:90099559
CCKW 353 Banjo 1944 s/n:309623