The GMC CCKW

Posted: **Thu Jan 31, 2008 2:50 pm**

I was adjusting the F.A. control lever following all instructions for making linkage adjustment in page O8B-2(TM10-1563),the clevis pin does not line up with hole in adjustable yoke and hole.I turned the yoke as necessary to line up holes in yoke and control rod lever.It is very important to check this adjustment.[/b]

Posted: **Sun Apr 20, 2008 7:10 am**

1)Jacking up one of the front wheel.2)put the lever in IN position.3)move the wheel jacked by hand.4)now we can be sure if it is engaging or not after this adjustment.

The GMC CCKW

Front Axle Control Lever Adjustment (Banjo)

Front Axle Control Lever Adjustment (Banjo)

After the adjustment of the FRONT AXLE control lever.