After letting my CCKW sit in the barn for about 9 months the brakes bled off. It was a small leak on a loose hose. After fixing that I got my friend over and we tryed to bleed the brakes as per the TM. I was getting very little fluid out of the wheels and almost none from the hydro-vac. I refilled the master cylinder and used low air pressure. I got a solid flow of fluid from the hydro-vac as well as the wheels, but still no pedal! I remember reading in the TM if the linkage going into the Master cylinder is not adjusted right,no brakes. I checked the linkage and the piston seemed to be traveling the length of the master cylinder, and I removed the discharge line, hit the brake pedal and got plenty of fluid. I put a new rebuild kit in the master cylinder a few years ago and it still looks almost new. So, I don't know where to go from here. Any help whould be appriciated.
Thanks, Guy
