Page 1 of 1
End curtains wanted for G506
Posted: Thu Apr 13, 2006 2:28 pm
by Craig
Side roll up straps also
Posted: Thu Apr 13, 2006 4:17 pm
by oldreliable9_47
might give Beachwood Canvas a call. They make them.
http://www.beachwoodcanvas.com/store/
Also Weebe Webbing..I think I spelled it right
Posted: Fri Apr 14, 2006 8:14 pm
by dr deuce
M-series curtains work
Posted: Fri Apr 14, 2006 11:13 pm
by Bill_Wolf
Craig,
Judith at New Life Resource up in Underhill VT does excellent Mil Canvas work.
That is who I use.
Bill
Posted: Sat Apr 15, 2006 8:41 am
by oldreliable9_47
Are they reproduction of original WWII style end curtains
Re:
Posted: Sat Apr 15, 2006 9:52 am
by Bill_Wolf
oldreliable9_47 wrote:Are they reproduction of original WWII style end curtains
If your question was directed to me about New Life Resources the best thing to do would be contact them at
NLRM@ncctv.net
The weasel top that I have, done by NLRM, looks very original
They have an ad in the most recent issue of MV Magazine, April 2006, Page 65.
Bill
Posted: Sat Apr 15, 2006 9:12 pm
by oldreliable9_47
Thanks Bill..I am looking around for some myself.
Posted: Sun Apr 16, 2006 5:29 am
by armydriver
I noticed that Beachwood is around $900.00 for the topwith web side roll up straps.
End curtains wanted for G506
Posted: Sun Apr 16, 2006 9:38 am
by Craig
Thanks for all the input. I got my top from New Life Resourse but they are not taking any new orders or even phone calls at the moment. As for M-series curtains I have three, two of which I have adapted to my truck. They work "OK" but they are a little wide and have to be wrapped around the rear upright to make them work. But with the top in place they work/look fine. While we are on the suject I would be willing to sell or trade the third end curtain, (missing one grommet on the bottom). I'm still trying to find the brace for holding the hood open and also the rear storage compartment door for a G506. Its the door at the back of the bed below the tail gate. I would trade even for either part. Thanks again, Craig
Posted: Sun Apr 16, 2006 11:51 am
by dr deuce
Funny, my M-series endflaps work fine the normal way they normally go on.
End curtains wanted for G506
Posted: Mon Apr 17, 2006 8:37 am
by Craig
What kind of truck do you have? M series are too wide for a WW2 G506.
Posted: Mon Apr 17, 2006 6:45 pm
by dr deuce
CCKW