End curtains wanted for G506

Craig · Post by **Craig** » Thu Apr 13, 2006 2:28 pm

Side roll up straps also

oldreliable9_47 · Post by **oldreliable9_47** » Thu Apr 13, 2006 4:17 pm

might give Beachwood Canvas a call. They make them.

http://www.beachwoodcanvas.com/store/

Also Weebe Webbing..I think I spelled it right

dr deuce · Post by **dr deuce** » Fri Apr 14, 2006 8:14 pm

M-series curtains work

Bill_Wolf · Post by **Bill_Wolf** » Fri Apr 14, 2006 11:13 pm

Craig,

Judith at New Life Resource up in Underhill VT does excellent Mil Canvas work.

That is who I use.

Bill

oldreliable9_47 · Post by **oldreliable9_47** » Sat Apr 15, 2006 8:41 am

Are they reproduction of original WWII style end curtains

Bill_Wolf · Post by **Bill_Wolf** » Sat Apr 15, 2006 9:52 am

oldreliable9_47 wrote:Are they reproduction of original WWII style end curtains

If your question was directed to me about New Life Resources the best thing to do would be contact them at NLRM@ncctv.net

The weasel top that I have, done by NLRM, looks very original

They have an ad in the most recent issue of MV Magazine, April 2006, Page 65.

Bill

oldreliable9_47 · Post by **oldreliable9_47** » Sat Apr 15, 2006 9:12 pm

Thanks Bill..I am looking around for some myself.

armydriver · Post by **armydriver** » Sun Apr 16, 2006 5:29 am

I noticed that Beachwood is around $900.00 for the topwith web side roll up straps.

Craig · Post by **Craig** » Sun Apr 16, 2006 9:38 am

Thanks for all the input. I got my top from New Life Resourse but they are not taking any new orders or even phone calls at the moment. As for M-series curtains I have three, two of which I have adapted to my truck. They work "OK" but they are a little wide and have to be wrapped around the rear upright to make them work. But with the top in place they work/look fine. While we are on the suject I would be willing to sell or trade the third end curtain, (missing one grommet on the bottom). I'm still trying to find the brace for holding the hood open and also the rear storage compartment door for a G506. Its the door at the back of the bed below the tail gate. I would trade even for either part. Thanks again, Craig

dr deuce · Post by **dr deuce** » Sun Apr 16, 2006 11:51 am

Funny, my M-series endflaps work fine the normal way they normally go on.

Craig · Post by **Craig** » Mon Apr 17, 2006 8:37 am

What kind of truck do you have? M series are too wide for a WW2 G506.

dr deuce · Post by **dr deuce** » Mon Apr 17, 2006 6:45 pm

The GMC CCKW