Knuckle seals
-
nwmv
- First Lieutenant
- Posts: 80
- Joined: Sat Jan 19, 2008 4:07 am
- Contact:
Knuckle seals
How many of you guys have replaced your knuckle felt seals on your split axle? I replaced mine last week along with the hub seals and repacked all the bearings quite a job The most difficult task was fitting the felt into the cast groove of the knuckle properly. The felt is quite a bit wider than the groove it fits in.
42 MB Slat
42 GPW Script
42 WC51
45 CCKW 353
42MBT
42 GPW Script
42 WC51
45 CCKW 353
42MBT
-
Corne Lauwerijssen
- First Lieutenant
- Posts: 141
- Joined: Thu Jun 08, 2006 1:10 am
- Location: Netherlands, Rucphen
Hi
I did that last year and it wasnt a difficult job. It only costed
a lot of time. Cant remember having problems with the felt seals.
But since I have clean knuckles, thus not covered with grease.
Corné
I did that last year and it wasnt a difficult job. It only costed
a lot of time. Cant remember having problems with the felt seals.
But since I have clean knuckles, thus not covered with grease.
Corné
194x GMC cckwx353 Cargo (cab1574, turrethole, winch, SWB)
1944 GMC cckw353 Cargo
1944 GMC cckw353 Open toolset (complete)
1945 1-tons trailer (Ben Hur type) (sold)
194x 1-tons trailer (Ben Hur type)
1945 Willys MB
1945 1/4-tons Bantam T-3
1944 PE-95G Willys Generatorset
1972 AM General M35A2 (sold)
1968 M50A2 Water tanker (sold)
1944 GMC cckw353 Cargo
1944 GMC cckw353 Open toolset (complete)
1945 1-tons trailer (Ben Hur type) (sold)
194x 1-tons trailer (Ben Hur type)
1945 Willys MB
1945 1/4-tons Bantam T-3
1944 PE-95G Willys Generatorset
1972 AM General M35A2 (sold)
1968 M50A2 Water tanker (sold)