Does the M35 Master cylinder fit the CCKW?

SpookyDad · Post by **SpookyDad** » Sat Aug 30, 2008 11:59 pm

Just to confirm, the master cylinder from a M35 will fit in the CCKW, right?

Neil G.

dr deuce · Post by **dr deuce** » Sun Aug 31, 2008 5:38 am

Yes, but see my previos post about the width when mounting. May need shims/washers

Bill_Wolf · Post by **Bill_Wolf** » Sun Aug 31, 2008 9:20 am

2 weeks ago I put a Wagner Surplus Military M-35 Master in my CCKW.

It was not as wide as the one coming out also a Wagner and did have to be shimmed. About 1/16 of an inch on each side of the cylinder. I went to Home depot and bought a 3/8" galvanized washers. They worked just fine to shim the master using the original bolts.

Works great!

Bill

nwmv · Post by **nwmv** » Sun Aug 31, 2008 11:50 am

I have NEW M35 master cylinders would love to trade towards parts. Last on eI used needed no shimming was a perfect fit straight across the board.

SpookyDad · Post by **SpookyDad** » Sun Aug 31, 2008 12:10 pm

What parts are you looking for?

Neil

nwmv · Post by **nwmv** » Mon Sep 01, 2008 2:41 pm

Hello Neil, I am interested in the engine side panels and also need the latches for the canvas doors. The latches that are on the cab inself. Also the plugs on the floor for the cab mounts and brake cylinder.
regards, Brian