Vehicle information

ghasp! · Post by **ghasp!** » Wed Mar 15, 2006 4:03 pm

Hi

I'm hopefully about to buy a CCKW from a vendor in France, who can't tell me much about the early history of the vehicle. What details he has only go back to 1954 when the French army took it on strength. He says the serial number is 435 876. Can anyone tell when and where it was made from that information?

Any help appreciated.

42cckw · Post by **42cckw** » Wed Mar 15, 2006 5:38 pm

Your truck was mfg January 1945 and as to were I belive GMC Truck & Coach Division, Pontiac Michigan. There are some other

you need to answer,short or long wheel base, winch or no winch, banjo or split axles ,type of rear body, most likely wood cargo . CCKW352 is a short wheel base or CCKW353 is a long wheel base just for starters.If you answer the questions I can give you the trucks complete ser#.

JIM 42CCKW

ghasp! · Post by **ghasp!** » Thu Mar 16, 2006 4:25 pm

Thanks for the info. It is a 353, open cab, not sure about the axles.
I have some pictures which I could send, but can't see how to attach them.

42cckw · Post by **42cckw** » Thu Mar 16, 2006 5:31 pm

I will get you as close as I can,you didn't answer all the

your ser# will go like this CCKW353 435876 A1 If it has no winch ,a cargo body and split type axles. A2 means the same only with banjo type axles. The suffix changes to a B if the truck has a winch.

A1.......... cargo body-no winch -split type axles
A2.......... cargo body- no winch-banjo type axles
B1.......... cargo body- with winch-split type axles
B2.......... cargo body-with winch- banjo type axles
There are other legends that apply that cover special body types like water or gasoline tankers or dump bodys known as tippers, the ones above cover the basic and most produced cargo types. Look for your ser# stamped into the frame on the passenger side just aft of the bumper on the flat side of your frame ,it may be filled in with paint and hard to find but it should be there ,you may have to do some sanding and take a fine scratch tool to dig the paint out of the ser# stamping

hope this helped you

About your pictures e-mail them to Bill and he probably would post them for you

JIM 42CCKW

Bill_Wolf · Post by **Bill_Wolf** » Thu Mar 16, 2006 6:16 pm

Info on how to post pictures can be found in the FAQ catagory of this board.

They have to be hosted on the net to post.

Bill

42cckw · Post by **42cckw** » Thu Mar 16, 2006 6:28 pm

THANKS BILL

ghasp! · Post by **ghasp!** » Fri Mar 17, 2006 9:09 am

Thanks again. I've had another look at the pictures and it has no winch. However, I'm new to these vehicles and I wouldn't know the difference between split or banjo axles even if I saw them

Degsy · Post by **Degsy** » Fri Mar 17, 2006 2:36 pm

The Banjo axles are a one piece casting with a large round diff casing. The split axles have a smaller diff casing and the axle is made in two parts held together with a ring of bolts to one side of the diff hence the term "split". Hope this helps.

Bill_Wolf · Post by **Bill_Wolf** » Fri Mar 17, 2006 2:57 pm

Repeat after me......

Google is my friend.....google is my friend.....

Found on Google

Split (Jeep I believe)

Bill

The GMC CCKW

Vehicle information

Vehicle information

ser #