Is this for GMC?

Karoshi · Post by **Karoshi** » Tue May 16, 2006 6:38 pm

Well its certainly the right sort of style, and it looks correct, but would be hard to tell for sure, as they all look much the same!

Ledog · Post by **Ledog** » Tue May 16, 2006 6:45 pm

What about the numbers on the label? Does it helps? It doesn't correspond to the GM part number.

Karoshi · Post by **Karoshi** » Tue May 16, 2006 10:41 pm

777 AAA, I'm afraid the label means nothing to me, but I guess that in keeping with sound military practice the same units were common across a range of vehicles.

So there are three things to consider:

1/. Does it fit? 5 hole fixing. So probably.

2/. Is the length correct, to reach the bottom of the tank? Its certainly "looks" about correct. and:

3/. Does it work? Why not connect it up outside the tank, and manually raise and lower the float arm to set if it gives full gauge movement.

armydriver · Post by **armydriver** » Wed May 17, 2006 8:33 am

It does look right and if the bolt hole pattern in the flange fits the bolt hole pattern on the tank and the length right, then it should work just fine.

Ledog · Post by **Ledog** » Wed May 17, 2006 12:08 pm

Ok, thanks. I will buy it.